Skip to content

Bill of materials

Top-down KiCad render — the board this BOM populates
The single-bridge v4 PCB. Two identical instances of this board are populated from the BOM below; the project total is two modules + spares.

The full BOM is at hardware/single-bridge-v4/bom.csv in the repository (GitHub renders CSV as a sortable table). The original BOM spreadsheet sources are also kept alongside for traceability:

Source Purpose
bom-source-v3_2.xlsx Original BOM authored against build guide v3.2. Lives next to the canonical CSV.
kicad-footprints.xlsx Footprint catalogue used during the KiCad netlist export.
hardware/legacy/iteration-3/CHB_BOM_v3_1.xlsx The older v3.1 BOM (IRFZ44N + IPD LS-PWM era). Preserved for iteration-history reference.

Headline totals (v3.2, project as a whole)

Section Items Need qty Subtotal (TL)
A. Power semiconductors 6 28 1 151.6
B. Sensing ICs 4 12 539.0
C. DC-bus bulk + protection 3 5 86.0
D. Gate-drive passives 4 60 24.0
E. Bootstrap 1 4 6.0
F. Snubber 2 16 36.0
G. Isolated supply passives 2 6 3.2
H. DC-bus sensing passives 5 13 5.8
I. Current-sense passives 2 2 0.6
J. Connectors + mechanical 5 35 132.5
Project total 34 lines 181 parts ≈ 1 985 TL

(All figures from bom-source-v3_2.xlsx "Complete BOM" sheet, recomputed for the as-built two-module project.)

Notable substitutions and gaps

MOSFET — IRFB4110 substituted for IRFZ44N at order time

The v3.2 source spreadsheet lists IRFZ44N (55 V, 49 A, 17.5 mΩ) at line A.1, but the as-built hardware uses IRFB4110 (100 V, 180 A, 4.5 mΩ). The substitution is documented in the firmware CHANGELOG (dead-time raised to 3 µs for the IRFB4110 power stage) and in Build Guide v4.0 §4 Power stage. The canonical bom.csv lists IRFB4110 with a TBD Motorobit URL pending confirmation.

Reference designators are placeholders

The Reference column in bom.csv uses ranges (Q1-Q4, R1, etc.) derived from the schematic structure. These are placeholders — the authoritative reference designators come from the KiCad annotation. They will be replaced after a tools/bom-validator.py cross-check against the KiCad netlist (planned).

Per-module vs. per-project quantities

The v3.2 source BOM lists project totals (two modules + spares). The canonical bom.csv follows the same convention. Per-module quantities are roughly half the Need column for most line items; sensing ICs split asymmetrically between the lower-bridge island (1× MCP3201) and the upper-bridge island (2× MCP3201).

Suppliers (Turkish domestic, by line frequency)

Supplier Lines Typical contents
Direnc.net 20 Passives, MCP3201, fast diodes, connectors
Motorobit 11 MOSFETs, TLP250, B0515S DC-DC, ACS712, 6N137, 78L05, TVS
Robotistan 3 Fuse holders, heatsinks, wire

International suppliers (Mouser / Digi-Key / LCSC) are not used by project preference — all parts come from the four approved Turkish vendors. See project conventions.