Skip to content

5-Level Cascaded H-Bridge Inverter

Modular cascaded H-bridge multilevel inverter built around two single-bridge PCB modules and an STM32 Nucleo-F303RE running phase-shifted carrier PWM at 5 kHz. Built as the ELE 401/402 graduation project at Hacettepe University EEE — Spring 2026.

Project status — May 2026

Hardware fabricated, populated, and bench-validated. Firmware deployed. Five distinct cascade output levels confirmed on the oscilloscope at 100 V cascade output; bridges thermally balanced under sustained load. Demonstration successful.

  •  Hardware


    Two identical single-bridge modules, 4-layer JLCPCB-fabricated, IRFB4110 power MOSFETs.

    Architecture

  •  Firmware


    STM32 F303RE source, PSC-PWM modulator, bit-banged isolated sensing, and the PySide6 dashboard.

    Firmware overview

  •  Build guide


    Canonical engineering reference (v4.0, May 2026). Supersedes the older v3.1 PDF in full.

    Build Guide v4.0

  •  Bring-up notes


    What we saw on the bench, what went wrong, what we changed.

    Bring-up

  •  Final report


    Consolidated graduation report — supersedes ELE 401 and ELE 402 interim reports.

    Final report

  •  Team & About


    Cereyan Hacıları + supervisor + institution + license.

    About

What's in this documentation

Section Contents
Hardware KiCad sources, gerbers, BOM, populated photos, and Build Guide v4.0.
Firmware STM32 source, the PSC-PWM modulator, the state machine, the UART protocol.
Dashboard The PySide6 operator interface — install, run, use.
Simulation The Simulink model and the THD analysis that informed the topology choices.
Bring-up First-bench-session notes and the hardware bring-up reference.
Design notes Standalone design-decision pieces — bootstrap fundamentals, CHB isolation, PSC vs. LSPWM, IGBT vs. MOSFET, grounding fix, plus the glossary.
Iteration history Per-iteration story: what was attempted, what failed, what was learned.
Roadmap Future work — what would be picked up after the graduation deliverable.
Final report Consolidated graduation report (supersedes ELE 401 + ELE 402 interim).
About Team, supervisor, institution, license.

Team

Cereyan Hacıları on the demo stand
Project group Cereyan Hacıları on the demo stand, under Assoc. Prof. Dr. Rasım Doğan.
Person Role
Furkan Emir Aksel Lead, firmware, dashboard
Ahmet Koçak Hardware, bring-up
Faruk Gökhan Abay Simulation, analysis
Mücahit Aydın Hardware, assembly

Hacettepe University, Department of Electrical and Electronics Engineering — Ankara, 2026.

Populated single-bridge v4 PCB module — IRFB4110 H-bridge with TLP250 optical gate drive and isolated MCP3201 sensing
One of two identical single-bridge v4 modules — 4-layer JLCPCB, IRFB4110 power MOSFETs in a full H-bridge, TLP250 optical gate drive on a B0515S isolated 15 V rail, bit-banged MCP3201 sensing through 6N137 optocouplers. Cascading two of these externally produces the 5-level output documented in the final report.